Kick-start your control development
HIL DSP Interface provides a pin-to-pin compatible interface between Typhoon HIL emulators and C2000 control cards. In less than 5 minutes you can plug a HIL DSP Interface to a Typhoon HIL real-time emulator, map the signals and run with a closed loop control.
You can now focus on DSP control code development, without worrying about schematic and PCB design. All required protocols, such as JTAG and UART, are available and accessible.
Ready solution for your classroom
HIL DSP Interface with?HIL402?workstation offers engaging, highly interactive and fun approach to learning power electronics and digital controls applied to grid connected converters, motor drives, renewables, active filters and smart grid applications. Students quickly get immersed by first running pre-packaged controller code examples under different operating conditions including grid disturbances and faults.
Subsequently, students progress and learn to develop open loop control, and then closed loop control, including PWM modulation, PLL synchronization with the grid, grid currents control and DC link voltage control. All this in a completely safe environment while working with “MW” of power.
HIL DSP Interface technical details
For more details take a look at the brochures: HIL DSP100 Interface and HIL DSP180 Interface
| Supported TI ControlCards | TMDSCNCD2808
TMDSCNCD28027 TMDSCNCD28035 TMDSCNCD28069 TMDSCNCD28335 |
TMDSCNCD28379D
TMDSCNCD28388D |
| Programming | via onboard USB | via USB on ControlCard |
| JTAG connector | 13-pin IDC | 13-pin IDC |
| CAN connector | RJ45 | RJ45 |
| Power | from HIL or external | from HIL or external |